Transaxle This procedure was included in the Owner's Manual for a Ford Focus. This same procedure may apply to other models and model years Valvoline Synchromesh Manual Transmission Fluid Q Chilton's Ford Focus. Chilton's Ford full-size cars Chilton's Toyota 4runner repair manual. Chilton's Toyota Celica User's Manual. Livewire TS. Part Numbers: Ford GM Page 2. California on pollution controlled motor vehicles.
It is always a good idea to turn- off any Ford offers F-Series. Super Duty Class A Motorhome. Built on a cutaway chassis — includes van cab section. Ford chassis Ford Cars. The British and German teams that worked on the original hatchback in the mid to late s set out to replace the aging Ford Focus and create something that could be sold all around the world.
Shortly afterward in came the sporty RS trim that boasted a 2-liter turbocharged engine and limited-slip-differential on the front axle the only one that was powered. Eventually, the release of the second-generation Ford Focus happened in and saw the car grow much larger and obviously longer with a stiffer bodyshell and more comfortable ride.
The first performance trim for the second generation was named the ST and featured a bhp 5 cylinder turbocharged engine from Volvo. Then the RS trim from the first generation made an appearance on the second generation in featuring an up-rated version of the ST engine. Measure the height of the headlamp bulb center from the ground and mark a 2. Page Turn Signal Control Lights 3.
Open the hood. Remove the battery cover. Remove the headlamp bulb cover by releasing the four snap hooks two top and two bottom. Note: On the left headlamp, pull the bulb cover approximately 1 inch rearward and then slide it out until the vertical aiming adjuster is accessible. When the dome lamp switch is in the off position, it will not illuminate when you open the doors.
Page 43 Lights Using the right bulbs Replacement bulbs are specified in the chart below. The correct bulbs will not damage the lamp assembly or void the lamp assembly warranty and will provide quality bulb burn time. To remove the high or low beam headlamp bulb: 1. Lift the hood and remove the bulb cover. Swivel the wire clip to the side and pull out the lamp. Page 45 2. Open the hood and remove the bulb socket from the headlamp unit by turning it counterclockwise.
Pull the bulb straight out of the bulb socket. Make sure the headlamp control is in the OFF position and then open the hatchback. From inside the luggage compartment remove the wing nut of the rear light assembly cover. Using a screw driver remove the fixings and trim from the body. Remove the socket from the lamp assembly 4.
Page 48 Lights Replacing high-mount brake lamp bulbs Sedan 1. Make sure the headlamp control is in the OFF position and open the luggage compartment. Using a screw driver remove the trim from the tailgate.
Pull the bulb holder from the lamp assembly. Page 49 Lights Replacing the luggage compartment lamp 1. Make sure the headlamp control is in the OFF position. Carefully pry out the light assembly from the holder with a flathead screwdriver. Pull the bulb straight out. Install in reverse order. Replacing interior lamps 1.
For intermittent operation, move control up one position and adjust the rotary control to the desired speed. For normal operation, move control up two positions. For high speed operation, move control up three positions. Page 51 Driver Controls Changing the wiper blades 1. Pull the wiper arm away from the vehicle. Turn the blade at an angle from the wiper arm.
Push the lock pin manually to release the blade and pull the wiper blade down toward the windshield to remove it from the arm. The horn can be operated when the ignition is off. To adjust your mirrors: 1. Rotate the control clockwise to adjust the right mirror and rotate the control counterclockwise to adjust the left mirror.
Page 54 Driver Controls Setting speed control The controls for using your speed control are located on the steering wheel for your convenience. Press the ON control and release 2. Accelerate to the desired speed. This will automatically return the vehicle to the previously set speed. Increasing speed while using speed control There are two ways to set a higher speed Turning off speed control Press the speed control OFF control. Note: When you turn off the speed control or the ignition, your speed control set speed memory is erased.
Page 57 The moon roof will move about 0. Press the switch again and again until the moon roof is closed. Have the system checked by your Ford Dealer immediately.
Smokers package kit is available through Ford Accessories. Make sure that the mat does not interfere with the operation of the accelerator or the brake pedal.
Release the cover at the sides and pull it out horizontally without tilting it. Make sure the cover is properly aligned when inserting it. Wagon Pull out the roller cover and secure the retaining points.
The load must be placed directly on the luggage rack. When loading the luggage rack, it is recommended to evenly distribute the load, as well as maintain a low center of gravity. In case of loss, replacement keys are available from your dealer. You should always carry a second key with you in a safe place in case you require it in an emergency.
The childproof locks are located on rear edge of each rear door and must be set separately for each door. The handle is composed of a material that will glow for hours in darkness following brief exposure to ambient light. Operation is subject to the following two conditions: 1 This device may not cause harmful interference, and 2 This device must accept any interference received, including interference that may cause undesired operation.
Note: the parking lamps will flash once. If any of the doors are not properly closed the horn will make two quick chirps. Page 67 Locks and Security To replace the battery: 1. Twist a thin coin between the two halves of the remote entry transmitter near the key ring. Remove the old battery. Page 68 Note: The SecuriLock passive anti-theft system is not compatible with non-Ford aftermarket remote start systems.
Use of these systems may result in vehicle starting problems and a loss of security protection. Note: Large metallic objects, electronic devices that are used to purchase gasoline or similar items, or a second coded key on the same key chain may cause vehicle starting issues. If a problem occurs with the SecuriLock system, the indicator will flash rapidly or glow steadily when the ignition is in the ON position.
If this occurs, the vehicle should be taken to an authorized dealer for service. Page 70 Locks and Security 2. Keep the ignition in the 3 ON position for at least one second, but no more than 10 seconds. Turn the ignition to the 1 OFF position. If there is any potential perimeter anti-theft problem with your vehicle, ensure ALL remote entry transmitters are taken to the dealership to aid in troubleshooting.
Do not pile cargo higher than the seatbacks to reduce the risk of injury in a collision or sudden stop. Page 73 Seating and Safety Restraints Adjusting the front manual seat Pull the lever located under the front edge of the seat to move the seat forward or backward. Turn the control to adjust the lumbar support.
Turn the handle to adjust the height of the seat. The maximum temperature is reached after five or six minutes. The indicator light on the switch is illuminated when activated. The heating will operate when the ignition switch is in position 2.
Heating with the engine off will drain the battery. When returning the seats back to their original positions, make sure they are fully locked and that the safety restraints are positioned in front of the seatback. The system is designed to help protect smaller drivers sitting close to the driver air bag by providing a lower air bag output level. The tone pattern will repeat periodically until the problem and warning light are repaired. If any of these things happen, even intermittently, have the Personal Safety System serviced at your dealership or by a qualified technician immediately.
Page 80 Seating and Safety Restraints Always transport children 12 years old and under in the back seat and always properly use appropriate child restraints. Combination lap and shoulder belts 1. Insert the belt tongue into the proper buckle the buckle closest to the direction the tongue is coming from until you hear a snap and feel it latch.
Failure to replace the belt and retractor assembly could increase the risk of injury in collisions. Page 82 This indicates the safety belt is now in the automatic locking mode. How to disengage the automatic locking mode Ford Motor Company recommends that all passenger safety belt assemblies and attaching hardware should be inspected by a qualified technician after any collision to verify that the automatic locking retractor feature for child seats is still working properly.
Page 83 Seating and Safety Restraints Safety belt pretensioner Your vehicle is equipped with safety belt pretensioners at the driver and front passenger seating positions. The safety belt pretensioner is a device which removes excess webbing from the safety belt system. The safety belt pretensioner uses the same crash sensor system as the front air bag supplemental restraint system SRS. Page 84 Seating and Safety Restraints Position the safety belt height adjusters so that the belt rests across the middle of your shoulder.
Failure to adjust the safety belt properly could reduce the effectiveness of the seat belt and increase the risk of injury in a collision. Safety belt warning light and indicator chime The safety belt warning light illuminates in the instrument cluster and a chime sounds to remind the occupants to fasten their safety belts. Page 85 Seating and Safety Restraints If Page 86 Seating and Safety Restraints Reasons given BeltMinder reminds us to take a few seconds to buckle up.
Page 87 Seating and Safety Restraints One time disable Any time the safety belt is buckled and then unbuckled during an ignition ON cycle, the BeltMinder will be disabled for that ignition cycle only. Page 88 slide bar-if equipped , shoulder belt height adjusters if equipped , shoulder belt guide on seatback if equipped , child safety seat LATCH and tether anchors, and attaching hardware, should be inspected after a collision.
Ford Motor Company Page Air Bags Seating and Safety Restraints recommends that all safety belt assemblies used in vehicles involved in a collision be replaced. Skip to content Home Search Submit. Clicking on the "view full screen" button will take you to a full screen version of the manual. Something Wrong? Newest Ford Focus Manuals.
0コメント